|
How to Install Gardall Wall Safe Models
Microwave Flange
Mounting Instructions.
1) After deciding on a location for the
safe on the wall, locate the studs in
that area either with a stud detector or
by tapping the wall to find the hollows
2) Mark the inside edge of the studs to
determine their location. Using those marks as your left and right outer
edge of the safe - draw in the top and bottom edge of the safe so that
you have a square the height and width of your safe (do not include the
flange in these dimensions). Cut your hole on the inside of these lines
about 1/2" in to allow for error or breaking of wall unevenly. Once you
have cut the wall you can look in to make sure you are between the
studs. Finish cutting wall and use your safe to insure a snug fit.
IT IS IMPORTANT TO TEST THE SAFE. Close and
lock the door of the safe. When you pull on the dial toward you
and push in on the dial toward the safe, there should be play in the
door (A loose fit). The play in the door prevents pressure on the
locking bolt that might cause the safe to stick shut.
YOU WANT THE SAFE TIGHT BETWEEN THE STUDS? If
the safe doesn't fit and the hole is too small, gradually shave a little
off the studs until the fit is comfortable.
If you are installing a wall safe with a
flange, no finishing of the wall is required for neatness. If your safe
has no flange, the hole you have cut could be framed for a professional
finish, keeping in mind that the safe should be concealed behind a
picture or mirror that must lie flush against the wall in order not to
look suspiciously obvious.
To mount safe between the studs drill through
the left and right side of the safe from the inside and into the studs.
|
